Sunday, March 18, 2012

Nylon 6/6 Machine Screw, Pan Head, Phillips Drive, M2.5-0.45, 4mm Length (Pack of 100)


Nylon 6/6 Machine Screw, Pan Head, Phillips Drive, M2.5-0.45, 4mm Length (Pack of 100)
Brand : Small Parts | Rate : | Price :
Post Date : Mar 18, 2012 03:17:54 | Usually ships in 24 hours

Nylon 6/6 Machine Screw, Pan Head, Phillips Drive, M2.5-0.45, 4mm Length (Pack of 100)

Machine Screws, also referred to as Machine Bolts, are often used with nuts or driven into tapped holes. They come in a variety of head types and drive styles, but are generally available in smaller sizes.

Nylon 6/6 is a general purpose thermoplastic with outstanding resistance to organic chemicals, acids and alkalis. Nylon wears well against other surfaces; it is readily machinable and may be milled, turned and cut with conventional machine tools. It does exhibit some dimensional swelling in wet applications which should be taken into account with its use. Tensile strength of this material is 12,000 psi (pounds per square inch).

Pan head fasteners have a low, large cylindrical head with a high rounded top edge for higher tightening torques - these fasteners are often recommended to replace older head styles such as round, binding, or truss-head where possible. The Phillips drive style was originally designed so that the driver would slip out under extreme torque, preventing over-tightening and damage to the fastener or the material.

A threaded fastener's size name includes information about the major external diameter (in millimeters), followed by the thread pitch (millimeters per thread), which indicates if it is coarse or fine. Coarse threads are better when working with brittle materials; they are sturdier and are easier to thread and unthread compared to fine. Coarse threading also allows for thicker coatings and platings.

  • Machine Screws are often used with nuts or driven into tapped holes
  • Nylon 6/6 is suitable where non-conductivity, corrosion resistance, and cost are important considerations
  • Pan head allows for higher tightening torques
  • Phillips drive is designed to cam out under too much torque
  • Coarse threads are better for brittle materials, and will assemble and disassemble more quickly than fine threads

Disclaimer : This site/page does not included in any the parts with amazon.com but it is participant in the amazon services LLC associates program by advertising and linking to amazon.com , Certain content that appears on this site comes from amazon services LLC. This content is provided 'as is' and is subject to change or removal at any time.



No comments:

Post a Comment


Twitter Facebook Flickr RSS



Français Deutsch Italiano Português
Español 日本語 한국의 中国简体。







Sponsor Links